User Tools

Site Tools


az100

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
az100 [2016/12/12 15:08]
kthorn
az100 [2016/12/12 15:51]
kthorn
Line 3: Line 3:
 ===== Notes on Usage ===== ===== Notes on Usage =====
  
 +  * Make sure your sample is centered in the cuvette. Imaging close to the edges of the cuvette often induces aberrations that result in poor image quality.
 +  * In general, the 5mm slit provides the best balance of light sheet width and taper. The smaller slits result in thicker light sheets with little benefit, unless you are using the 1x objective with a low zoom.
   * Don't use zooms less than 2x unless absolutely necessary. There are substantial aberrations at the edges of field of view at low zooms.   * Don't use zooms less than 2x unless absolutely necessary. There are substantial aberrations at the edges of field of view at low zooms.
-  * Below 3x zoom, set the CameraCrop parameter to 2048 x 2048 - this eliminates aberrations present at the edges of the field of view at these lower magnifications.+  * At 3x zoom and below, set the CameraCrop parameter to 2048 x 2048 - this eliminates aberrations present at the edges of the field of view at these lower magnifications.
   * With the 5x objective, you may need to adjust the AZ100 Z position in steps as small as 2 um to get an accurate focus.   * With the 5x objective, you may need to adjust the AZ100 Z position in steps as small as 2 um to get an accurate focus.
  
/var/www/html/dokuwiki/data/pages/az100.txt · Last modified: 2016/12/12 15:51 by kthorn